Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TRAX PREMIER, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 112 (FRONT SUSPENSION SYSTEM)REPAIR INSTRUCTIONSSTABILIZER SHAFT REPLACEMENTINSTALLATION PROCEDURE
2019 Chevrolet Trax Premier, AWD
Installation Procedure
2019 Chevrolet Trax Premier, AWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
Position the stabilizer shaft (1) on the drivetrain and front suspension frame.
- NOTE:
Start ALL fasteners by hand before tightening.
Front Stabilizer Shaft Insulator Clamp Bolt(2) - Install[4x]
- Front Stabilizer Shaft Insulator Clamp Nut(1) - Install and tighten[4x] 22 N.m (16 lb ft)
- Raise the rear of the drivetrain and front suspension frame.
- Install ALL drivetrain and front suspension frame bolts. Drivetrain and Front Suspension Frame Replacement (Long Cradle)Drivetrain and Front Suspension Frame Replacement (Short Cradle)Drivetrain and Front Suspension Frame Replacement (Long Cradle - V5O)
- Remove the adjustable stands from underneath the vehicle.
- Rear Transmission Mount Through Bolt - Install - Transmission Mount Bracket Replacement - Rear (FWD)Transmission Mount Bracket Replacement - Rear (AWD)
- Exhaust Isolator@Drivetrain and Front Suspension Frame - Install[2x] - Exhaust Front Pipe Replacement (LUV)Exhaust Front Pipe Replacement (2H0)Exhaust Front Pipe Replacement (LE2)
- Front Lower Control Arm@Steering Knuckle - Install[2x] - Lower Control Arm Replacement
- Front Stabilizer Shaft Link@Front Stabilizer Shaft - Install[2x] - Stabilizer Shaft Link Replacement
- Steering Linkage Outer Tie Rod@Steering Knuckle - Install[2x] - Steering Linkage Outer Tie Rod Replacement
- Front Wheelhouse Liner-Left Side - Install - Front Wheelhouse Liner Replacement (Chevrolet)Front Wheelhouse Liner Replacement (Buick)
- Drivetrain and Front Suspension Frame Transmission Protector - Install - Drivetrain and Front Suspension Frame Transmission Protector Replacement
- Install the front tire and wheel assemblies. Tire and Wheel Removal and Installation
- Install the intermediate steering shaft lower universal joint. Intermediate Steering Shaft Replacement (N40)Intermediate Steering Shaft Replacement (NJ1)
- Measure and adjust the wheel alignment. Wheel Alignment Measurement
CAUTION:
Refer to Fastener Caution .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.