Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TRAX PREMIER, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 107 (SHIFT LOCK CONTROL SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDTC B270ACIRCUIT/SYSTEM VERIFICATION
2019 Chevrolet Trax Premier, AWD
Circuit/System Verification
2019 Chevrolet Trax Premier, AWDSECTION Circuit/System Verification
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition ON / Vehicle in Service Mode.
- Verify the scan tool Brake Transmission Shift Interlock Solenoid Actuator Command parameter changes from Inactive to Active when the brake pedal is applied.
- If the Brake Transmission Shift Interlock Solenoid Actuator Command does not change
Refer to Stop Lamps Malfunction
- Go to next step: If the Brake Transmission Shift Interlock Solenoid Actuator Command changes
- If the Brake Transmission Shift Interlock Solenoid Actuator Command does not change
- Verify the S3 Transmission Shift Lever moves out of the PARK position when the brake pedal is applied.
- If the the S3 Transmission Shift Lever does not move out of the PARK position
Refer to Circuit/System Testing.
- Go to next step: If the S3 Transmission Shift Lever does move out of the PARK position
Go to next step: All OK.
- If the the S3 Transmission Shift Lever does not move out of the PARK position
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.