Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
Position the propeller shaft (1) in the vehicle.
Install two of the rear propeller shaft bolts (1) and washer (2) to hold the propeller shaft in place to the differential clutch flange.
Install two of the front propeller shaft bolts (1) and washer (2) to hold the propeller shaft in place to the front differential pinion flange.
Position the propeller shaft center bearing (2) in the mounting bracket.
- Install the center bearing bolts (1) and tighten to 42 N.m (31 lb ft).
Install the remaining rear propeller shaft bolts (1) and washers (2) and tighten the bolts (1) to 36 N.m (27 lb ft).
Install the remaining front propeller shaft bolts (1) and washers (2) and tighten the bolts (1) to 36 N.m (27 lb ft).
- Install the exhaust intermediate underbody heat shield. Exhaust Intermediate Underbody Heat Shield Replacement
- Install the muffler assembly. Exhaust Muffler Replacement (2H0)Exhaust Muffler Replacement (LUV)Exhaust Muffler Replacement (LE2)
- Remove the support and lower the vehicle.
Refer to Fastener Caution .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.