Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TRAX PREMIER, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 103 (DRUM BRAKE SYSTEM)REPAIR INSTRUCTIONSBRAKE DRUM REPLACEMENTINSTALLATION PROCEDURE
2019 Chevrolet Trax Premier, AWD
Installation Procedure
2019 Chevrolet Trax Premier, AWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
- Using the CH-42450-A wheel hub resurfacing kit to clean the wheel hub flange of any corrosion.
- Adjust the drum brakes. Refer to Drum Brake Adjustment .
Install the brake drum (1).
- CAUTION:
Refer to Fastener Caution .
Install the brake drum bolt (1) and tighten to 9 N.m (80 lb in).
- Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
- Apply the brakes 2 or 3 times to seat and center the brake shoes on the brake drum.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.