SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TRAX PREMIER, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 102 (DISC BRAKE SYSTEM)REPAIR INSTRUCTIONSFRONT DISC BRAKE PADS REPLACEMENTINSTALLATION PROCEDURE
2019 Chevrolet Trax Premier, AWD

Installation Procedure

2019 Chevrolet Trax Premier, AWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Thoroughly clean the contact surfaces of the brake caliper bracket of any corrosion or debris.
  2. GM2375917
    NOTE:

    If installing new disc brake pads, install new disc brake pad springs.

    Install the upper and lower disc brake pad springs (1).

  3. GM2375916
    NOTE:

    Note the location of the brake pad wear sensor for correct installation.

    Install the inner disc brake pad (1).

  4. Install the outer disc brake pad (2).
  5. Position the brake caliper over the disc brake pads and to the caliper bracket.
  6. GM2375915
    CAUTION:

    Refer to Fastener Caution .

    Using a backup wrench to hold the brake caliper guide pin stationary, install the lower brake caliper guide pin bolt (1) and tighten to 40 N.m (30 lb ft).

  7. Install the tire and wheel assembly. Tire and Wheel Removal and Installation
  8. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
  9. Slowly release the brake pedal.
  10. Wait 15 seconds, then repeat steps 8 and 9 until a firm brake pedal is obtained. This will properly seat the brake caliper piston and brake pads.
  11. Fill the master cylinder reservoir. Brake Master Cylinder Reservoir Filling
  12. Burnish the brake pads and rotors. Brake Pad and Rotor Burnishing 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.