Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
Upon re-assembly index the temperature valve gear (1) large female tooth to the mode valve lever (2) large male tooth as indicated by the arrows for proper alignment.
- CAUTION:
Refer to Fastener Caution .
Temperature Valve Gear(3) - Install
- Temperature Valve Gear Retainer(2) - Install
- Temperature Valve Gear Bolt(1) - Install and tighten 1.5 N.m (13 lb in)
Temperature Control Cable(2)@Temperature Valve Gear - Install - Temperature Control Cable Replacement (C60)
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.