Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TRAX PREMIER, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1 (HEATING SYSTEM, VENTILATION SYSTEM, AND AIR CONDITIONING SYSTEM)REPAIR INSTRUCTIONSAIR CONDITIONING COMPRESSOR HOSE REPLACEMENT (LE2)INSTALLATION PROCEDURE
2019 Chevrolet Trax Premier, AWD
Installation Procedure
2019 Chevrolet Trax Premier, AWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
- Install air conditioning compressor hose to the vehicle.
Install NEW sealing washers.(2) - Air Conditioning System Seal Replacement
- Air Conditioning Compressor Hose(1) - Install
- Air Conditioning Compressor Hose Bolt(3) - Install and tighten 22 N.m (16 lb ft)
Front Compartment Front Center Insulator Replacement (4) - Install
Install NEW sealing washers.(3)
- Air Conditioning Compressor Hose(2) - Install
- Air Conditioning Compressor Hose Nut(1) Install and tighten 22 N.m (16 lb ft)
- Air Cleaner Outlet Duct Replacement - Install
- Recharge the refrigerant. Refrigerant Recovery and Recharging (R-134a)
CAUTION:
Refer to Fastener Caution .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.