Air Conditioning (A/C) Refrigerant Pressure Sensor Replacement (2H0)

2019 Chevrolet Trax Premier, AWDSECTION Air Conditioning (A/C) Refrigerant Pressure Sensor Replacement (2H0)
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
GM2811444
Callout Component Name
Preliminary Procedure 
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
1 Air Conditioning Refrigerant Pressure Sensor
CAUTION:

Refer to Fastener Caution .


Procedure 
Disconnect the electrical connector from the pressure sensor.
NOTE:

Remove and discard the O-ring and replace with NEW only. Refer to Air Conditioning O-Ring Seal Replacement .


Tighten 
6 N.m (53 lb in)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.