Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TRAX PREMIER, AWDREPAIR AND DIAGNOSISENGINE MECHANICALSTARTERBATTERY, CHARGING SYSTEM AND STARTING SYSTEMREPAIR INSTRUCTIONSSTARTER REPLACEMENT (LE2-FWD)INSTALLATION PROCEDURE
2019 Chevrolet Trax Premier, AWD
Installation Procedure
2019 Chevrolet Trax Premier, AWDSECTION Installation Procedure
Starter (3) - Install
- Starter Mounting Bolt (2) Install and tighten 58 N.m (43 lb ft)
- Starter Mounting Nut (1) Install and tighten 58 N.m (43 lb ft)
{ If equipped }Engine Coolant Heater Cord (2) - Connect
- Battery Positive Cable (4) - Install
- Starter Solenoid Cable Nut (3) Install and tighten 12.5 N.m (111 lb in)
- Electrical Connector (1) - Connect
- Front Wheel Drive Intermediate Shaft Replacement (LE2 with MNH) - Install
- Lower the vehicle.
- Battery Negative Cable Disconnection and Connection (without KL9) Battery Negative Cable Disconnection and Connection (with KL9)
CAUTION:
Refer to Fastener Caution
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.