Front Side Door Window Regulator Replacement (Power)

2019 Chevrolet Trax Premier, AWDSECTION Front Side Door Window Regulator Replacement (Power)
GM2780630Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure Remove the front side door window from the window regulator guide nuts. Do Not remove the window from the vehicle, raise the window to the full up position, tape in place. Refer to Front Side Door Window Replacement .
1 Front Side Door Power Window Regulator Bolts (Qty: 4)
CAUTION:

Refer to Fastener Caution .

Procedure

  1. Remove the front side door water deflector.
  2. Disconnect the electric connector from the regulator motor.

Tighten 
11 N.m (97 lb in)
2 Front Side Door Power Window Regulator

Procedure

  1. Transfer the front side door window regulator motor. Refer to Front Side Door Window Regulator Motor Replacement .
  2. Inspect the door window for proper operation before installing the door trim.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.