Front Side Door Stationary Window Replacement

2019 Chevrolet Trax Premier, AWDSECTION Front Side Door Stationary Window Replacement
GM2791432Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedures Remove the front side door window weatherstrip. Refer to Front Side Door Window Weatherstrip Replacement 
1 Front Side Door Stationary Window

Procedure

  1. With the assembly on a clean and dry surface, roll the stationary window out of the weatherstrip.
  2. Ensure that the window weatherstrip and stationary window is fitted around the inner door frame fully.
  3. Install the window to the front and rear guides, hand move the window up and down before installing the window to the regulator.
  4. Carefully move the window upward in short slow intervals, while ensuring that the window remains in the guide.
  5. Inspect the window for proper operation before installing the trim.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.