SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TRAX PREMIER, AWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTWIPER/WASHER SYSTEMSWIPER SYSTEM AND WASHER SYSTEMREPAIR INSTRUCTIONSWINDSHIELD WASHER PUMP HOSE REPLACEMENT (ENCORE)
2019 Chevrolet Trax Premier, AWD

Windshield Washer Pump Hose Replacement (Encore)

2019 Chevrolet Trax Premier, AWDSECTION Windshield Washer Pump Hose Replacement (Encore)
GM3512005Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Reposition the front compartment fuse block. Refer to Front Compartment Fuse Block Replacement .
  2. Remove the front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement (Encore) .
1 Windshield Washer Pump Hose

Procedure

  1. Place a collecting container under the windshield washer solvent container.
  2. Disconnect the windshield washer pump hose from the windshield washer pump.
  3. Lower the vehicle.
  4. Disconnect the windshield washer pump hose from the connection piece at the air inlet grille panel.
  5. Remove the windshield washer pump hose from the two clips on the windshield washer solvent container.
NOTE:

Observe the routing of the windshield washer pump hose for installation purposes.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.