SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TRAX PREMIER, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTINFOTAINMENTCELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEM - REPAIR INSTRUCTIONSREPAIR INSTRUCTIONSCOMMUNICATION INTERFACE MODULE BRACKET REPLACEMENT (TRAX)
2019 Chevrolet Trax Premier, AWD

Communication Interface Module Bracket Replacement (Trax)

2019 Chevrolet Trax Premier, AWDSECTION Communication Interface Module Bracket Replacement (Trax)
GM4500532Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Serial Data Gateway Bracket Replacement (Trax)
1 Communication Interface Module Bracket Bolt[2x]
CAUTION:

Fastener Caution


Tighten 
2.5 N.m (22 lb in)
2 Communication Interface Module Bracket

Procedure

  1. Disconnect the electrical connectors.
  2. Transfer components as necessary.
  3. The top of the bracket has 2 locking tabs on an arm that goes above the instrument panel tie bar, lift the arm up and out of the locking holes to release the bracket.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.