SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TRAX PREMIER, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTHEATED GLASS/DEFOGGERSFIXED AND MOVEABLE WINDOW SYSTEMREPAIR INSTRUCTIONSREAR SIDE DOOR WINDOW WEATHERSTRIP REPLACEMENT
2019 Chevrolet Trax Premier, AWD

Rear Side Door Window Weatherstrip Replacement

2019 Chevrolet Trax Premier, AWDSECTION Rear Side Door Window Weatherstrip Replacement
GM5245664Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
WARNING:

Glass and Sheet Metal Handling Warning

Preliminary Procedures

  1. Rear Side Door Window Regulator Replacement (Power) Rear Side Door Window Regulator Replacement 
  2. After the window has been detached from the regulator lower window into the door panel.
  3. Rear Side Door Window Outer Sealing Strip Replacement 
1 Rear Side Door Window Weatherstrip Upper Screw
CAUTION:

Refer to Fastener Caution .

Procedure

  1. Pull the weatherstrip out of the upper retainer to expose the upper screw.
  2. Remove the weatherstrip from the rear lower guide.
  3. In order to remove the window weatherstrip from the door frame, remove the window regulator and lower the window down in the door panel so that the rear window weatherstrip can be separated from the door frame.

Tighten 
3 N.m (27 lb in)
2 Rear Side Door Window Weatherstrip Lower Bolt
Tighten 
9 N.m (80 lb in)
3 Rear Side Door Window Weatherstrip

Procedures

  1. Insert the weatherstrip downward in the guide until fully seated.
  2. Carefully move the regulator upward for short slow intervals, while ensuring that the window remains in the guides.
  3. Inspect the door window for proper operation before installing the door trim.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.