Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Rear Body Structure Stop Lamp Bracket Replacement (Trax)
2019 Chevrolet Trax Premier, AWDSECTION Rear Body Structure Stop Lamp Bracket Replacement (Trax)
| Callout | Component Name |
|---|---|
| Preliminary Procedure Rear Body Structure Stop Lamp Replacement (Trax with UGE) Rear Body Structure Stop Lamp Replacement (Trax with TVM) |
|
| 1 | Rear Body Side Structure Stop Lamp Bracket Screw [4x]
CAUTION:
Refer to Fastener Caution . Tighten 2.5 N.m (22 lb in) |
| 2 | Rear Body Side Structure Stop Lamp Bracket Procedure Release the plastic retaining tabs. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.