SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TRAX PREMIER, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTENTERTAINMENT SYSTEMSCELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEM - SPECIAL TOOLS AND EQUIPMENTSPECIAL TOOLS AND EQUIPMENTSPECIAL TOOLS (MIT TOOL INSTRUCTIONS)HOLDEN RADIO BLUETOOTH PAIRING INSTRUCTIONS
2019 Chevrolet Trax Premier, AWD

Holden Radio Bluetooth Pairing Instructions

2019 Chevrolet Trax Premier, AWDSECTION Holden Radio Bluetooth Pairing Instructions
  1. Using the radio controls, place the radio into "Discoverable Mode".
  2. Place the MIT into Bluetooth mode by pressing TEST SELECTOR until the Bluetooth LED is illuminated.
  3. With the MIT in Bluetooth mode Press and Release the #1 button (the Bluetooth LED will begin to slowly blink).
  4. Now Press and release the PAIR/CALL button on the MIT (the Bluetooth LED will begin to blink a little faster).
  5. On the radio Enter the PASSKEY when prompted: (press "0000" then Press "OK").
  6. The MIT and radio will PAIR and CONNECT (the Bluetooth LED will be Fast Flashing).
  7. Use as regular MIT at this point.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.