SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TRAX LS, FWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINTERIOR/EXTERIOR TRIMSEAT HARDWARE, TRIM, AND UPHOLSTERYREPAIR INSTRUCTIONSFRONT SEAT BACK FRAME REPLACEMENT
2019 Chevrolet Trax LS, FWD

Front Seat Back Frame Replacement

2019 Chevrolet Trax LS, FWDSECTION Front Seat Back Frame Replacement
GM2775208Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Remove the driver or passenger seat. Refer to Front Seat Removal and Installation 
  2. Remove the driver or passenger seat cushion outer finish panel. Refer to Driver or Passenger Seat Cushion Outer Finish Panel Replacement (Power) Driver or Passenger Seat Cushion Outer Finish Panel Replacement (Manual) 
  3. Remove the driver or passenger seat inner recliner finish cover. Refer to Front Seat Inner Recliner Finish Cover Replacement (Driver) Front Seat Inner Recliner Finish Cover Replacement (Passenger) Front Seat Inner Recliner Finish Cover Replacement (Passenger Outboard with AG5) Front Seat Inner Recliner Finish Cover Replacement (Passenger Inboard with AG5) 
1 Driver or Passenger Seat Back Cushion Frame Bolt (Qty: 4)
CAUTION:

Refer to Fastener Caution .


Tighten 
22 N.m(16 lb ft)
2 Driver or Passenger Seat Back Cushion Frame

Procedure

  1. Disconnect electrical connectors as needed.
  2. If replacing with a new front seat back cushion frame, transfer components as necessary.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.