Radio Antenna Cable Replacement

2019 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION Radio Antenna Cable Replacement
WARNING: This page is about a different car, the 2018 Chevrolet Sonic. However, it is still accessible from the selected car via links, so may be relevant.
GM2699304Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary ProceduresΒ 
Remove the instrument panel assembly. Refer to Instrument Panel Assembly Replacement .
1 Radio Antenna Cable

Procedures

  1. Locate the radio antenna cable in the instrument panel wiring harness assembly.
  2. Carefully cut the electrical tape.
  3. Disconnect electrical connectors.
  4. Replace the radio antenna cable.
  5. Secure the radio antenna cable within the electrical conduit.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.