Radio Antenna Base Replacement

2019 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION Radio Antenna Base Replacement
WARNING: This page is about a different car, the 2018 Chevrolet Sonic. However, it is still accessible from the selected car via links, so may be relevant.
GM2496816Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Lower the rear of the headlining trim panel. Refer to Headlining Trim Panel Replacement (Hatchback with Sunroof)Headlining Trim Panel Replacement (Hatchback without Sunroof)Headlining Trim Panel Replacement (Sedan with Sunroof)Headlining Trim Panel Replacement (Sedan without Sunroof) .
1 Radio Antenna Base Fastener
CAUTION:

Refer to Fastener Caution .


Tighten 
9 N.m (80 lb in)
2 Radio Antenna Base Retainer
3 Radio Antenna Base Assembly
Procedure 
Disconnect the electrical connectors.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.