Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TAHOE LS, 4WD, GAS/ETHANOLREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 98 (CELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESONSTAR AUDIO MALFUNCTIONCIRCUIT/SYSTEM VERIFICATION
2019 Chevrolet Tahoe LS, 4WD, Gas/Ethanol
Circuit/System Verification
2019 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION Circuit/System Verification
WARNING: This page is about a different car, the 2018 Chevrolet Sonic. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition ON/vehicle in Service Mode, radio ON.
- Verify that audio is heard clearly through all speaker channels when tuning radio to a known good station.
- If audio is not heard clearly
Refer to Speaker Malfunction
- Go to next step: If audio is heard clearly
- If audio is not heard clearly
- Verify that the Connecting to OnStar® message is heard clearly through the audio system when the OnStar® blue button is pressed.
- If OnStar message is noisy or distorted
Refer to Circuit/System Testing
- Go to next step: If OnStar message is heard clearly
- If OnStar message is noisy or distorted
- All OK.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.