SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TAHOE LS, 4WD, GAS/ETHANOLREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 95 (ENGINE CONTROLS/FUEL - 1.8L (LUW LWE) - DTC P0010 TO DTC P0420)DIAGNOSTIC INFORMATION AND PROCEDURESDTC P00F4-P00F6COMPONENT TESTING
2019 Chevrolet Tahoe LS, 4WD, Gas/Ethanol

Component Testing

2019 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION Component Testing
WARNING: This page is about a different car, the 2018 Chevrolet Sonic. However, it is still accessible from the selected car via links, so may be relevant.

Multifunction Intake Air Sensor

  1. Ignition OFF, disconnect the harness connector at the B75C Multifunction Intake Air sensor.
    2. NOTE:

    A thermometer can be used to test the sensor off the vehicle.

  2. Test the IAT sensor 1 by varying the sensor temperature while monitoring the sensor resistance. Compare the readings with the Temperature Versus Resistance - Intake Air Temperature Sensor (Bosch Sensor) table for Bosch Sensors. The resistance values should be in range of the table values.
    • If not within the specified range. 

      Replace the B75C Multifunction Intake Air sensor.

    • Go to next step: If within the specified range. 
  3. All OK
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.