SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TAHOE LS, 4WD, GAS/ETHANOLREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 88 (REAR SUSPENSION SYSTEM)SPECIFICATIONSFASTENER SPECIFICATIONS
2019 Chevrolet Tahoe LS, 4WD, Gas/Ethanol

Fastener Specifications

2019 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION Fastener Specifications
WARNING: This page is about a different car, the 2018 Chevrolet Sonic. However, it is still accessible from the selected car via links, so may be relevant.
Single Use Threaded Fastener/Component Tightening Specifications

Application Specification
Metric (English)
NOTE:

All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. 
Rear Axle Mounting Bolt  
  • First Pass:
 160 N.m (118 lb ft)
  • Final Pass:
 30 - 45 Degrees
Rear Shock Absorber Lower Bolt  
  • First Pass:
 100 N.m (74 lb ft)
  • Final Pass:
 90 - 105 Degrees
Reusable Threaded Fastener Tightening Specifications

Application Specification
Metric (English)
NOTE:

All fasteners listed in this table can be reused after removal. 
Rear Shock Absorber Upper Bolt 58 N.m (43 lb ft)
Rear Wheel Bearing/Hub Mounting Bolt 58 N.m (43 lb ft)
Rear Wheel Speed Sensor Bolt 6 N.m (53 lb in)
Shock Absorber Nut 25 N.m (18 lb ft)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.