Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TAHOE LS, 4WD, GAS/ETHANOLREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 86 (SEAT BELT SYSTEM)SPECIFICATIONSFASTENER SPECIFICATIONS
2019 Chevrolet Tahoe LS, 4WD, Gas/Ethanol
Fastener Specifications
2019 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION Fastener Specifications
WARNING: This page is about a different car, the 2018 Chevrolet Sonic. However, it is still accessible from the selected car via links, so may be relevant.
Reusable Threaded Fastener Tightening Specifications
| Application | Specification |
|---|---|
| Metric (English) | |
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
| Driver or Passenger Seat Belt Buckle Fastener | 45 N.m (33 lb ft) |
| Driver or Passenger Seat Shoulder Belt Fastener | 45 N.m (33 lb ft) |
| Front Seat Shoulder Belt Guide Adjuster Bolt | 45 N.m (33 lb ft) |
| Rear Seat Belt Buckle Fastener | 45 N.m (33 lb ft) |
| Rear Seat Center Shoulder Belt Buckle Fastener | 45 N.m (33 lb ft) |
| Rear Seat Center Shoulder Belt Fastener | 45 N.m (33 lb ft) |
| Rear Seat Shoulder Belt Anchor Plate Fastener | 45 N.m (33 lb ft) |
| Rear Seat Shoulder Belt Bracket Fastener | 45 N.m (33 lb ft) |
| Rear Seat Shoulder Belt Fastener | 45 N.m (33 lb ft) |
| Rear Seat Shoulder Belt Retractor Fastener | 45 N.m (33 lb ft) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.