Remote Control Door Lock Receiver Replacement (5HB)

2019 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION Remote Control Door Lock Receiver Replacement (5HB)
WARNING: This page is about a different car, the 2018 Chevrolet Sonic. However, it is still accessible from the selected car via links, so may be relevant.
GM4543555Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary ProcedureΒ 
Quarter Inner Trim Finish Panel - Left Side - Remove - Quarter Inner Trim Finish Panel Replacement (Hatchback)
1 Remote Control Door Lock Receiver

Procedure

  1. Push tabs on bottom of remote control door lock receiver and rotate out.
  2. Disconnect the electrical connector.
  3. Perform the necessary programming and setup procedure:Control Module References
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.