Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TAHOE LS, 4WD, GAS/ETHANOLREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 66 (ANTILOCK BRAKE SYSTEM)REPAIR INSTRUCTIONSELECTRONIC BRAKE CONTROL MODULE REPLACEMENTINSTALLATION PROCEDURE
2019 Chevrolet Tahoe LS, 4WD, Gas/Ethanol
Installation Procedure
2019 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION Installation Procedure
WARNING: This page is about a different car, the 2018 Chevrolet Sonic. However, it is still accessible from the selected car via links, so may be relevant.
Install the EBCM (1) to the BPMV.
- CAUTION:
Refer to Fastener Caution .
Install the EBCM bolts (1) and tighten to 3 N.m (26 lb in).
- Connect the EBCM electrical connector.
- Install the battery tray. Refer to Battery Tray Replacement .
- Program the EBCM. Refer to Control Module References .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.