Rear Side Door Window Weatherstrip Replacement (Hatchback)

2019 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION Rear Side Door Window Weatherstrip Replacement (Hatchback)
WARNING: This page is about a different car, the 2018 Chevrolet Sonic. However, it is still accessible from the selected car via links, so may be relevant.
GM2476172Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Remove the rear side door window. Refer to Rear Side Door Window Replacement (Hatchback) .
1 Rear Side Door Window Weatherstrip

Procedure

  1. Remove the rear side door water deflector.
  2. Remove the weatherstrip from the front and rear lower window guides.
  3. Grasp both upper corners, pull downward releasing the weatherstrip from the door frame.
  4. Insert the weatherstrip downward in the window guides until fully seated.
  5. Carefully move the regulator upward for short slow intervals, while ensuring that the window remains in the guides.
  6. Inspect the door window for proper operation before installing the door trim panel.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.