SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TAHOE LS, 4WD, GAS/ETHANOLREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 63 (FIXED AND MOVEABLE WINDOW SYSTEM)REPAIR INSTRUCTIONSREAR SIDE DOOR WINDOW REGULATOR REPLACEMENT (HATCHBACK)
2019 Chevrolet Tahoe LS, 4WD, Gas/Ethanol

Rear Side Door Window Regulator Replacement (Hatchback)

2019 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION Rear Side Door Window Regulator Replacement (Hatchback)
WARNING: This page is about a different car, the 2018 Chevrolet Sonic. However, it is still accessible from the selected car via links, so may be relevant.
GM2476168Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
WARNING:

Refer to Glass and Sheet Metal Handling Warning .

Preliminary Procedure Remove the front side door window from the guide. Do not remove the window from the vehicle, raise the window to the fully up position, tape in place. Refer to Rear Side Door Window Replacement (Hatchback) .
1 Rear Side Door Window Regulator Screw (Qty: 3)
CAUTION:

Refer to Fastener Caution .

Procedure

  1. Remove the rear side door water deflector.
  2. Loosen the window guide nuts. Do not remove the nuts from the guide.
  3. Disconnect the door electrical connector.
  4. Remove the rear side door window from the guide. Refer to Rear Side Door Window Rear Guide Replacement .

    Do not remove the window from the vehicle, raise the window to the fully up position, tape in place.


Tighten 
11 N.m (97 lb in)
2 Rear Side Door Window Regulator

Procedure

  1. Transfer the rear side door window regulator motor. Refer to Rear Side Door Window Regulator Motor Replacement .
  2. Inspect the door window for proper operation before installing the door trim panel.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.