SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TAHOE LS, 4WD, GAS/ETHANOLREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 63 (FIXED AND MOVEABLE WINDOW SYSTEM)REPAIR INSTRUCTIONSFRONT SIDE DOOR WINDOW REGULATOR REPLACEMENT
2019 Chevrolet Tahoe LS, 4WD, Gas/Ethanol

Front Side Door Window Regulator Replacement

2019 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION Front Side Door Window Regulator Replacement
WARNING: This page is about a different car, the 2018 Chevrolet Sonic. However, it is still accessible from the selected car via links, so may be relevant.
GM2425013Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
WARNING:

Refer to Glass and Sheet Metal Handling Warning .

Preliminary Procedure Remove the front side door window from the guide. Do Not remove the window from the vehicle, raise the window to the fully up position, tape in place. Refer to Front Side Door Window Replacement .
1 Front Side Door Window Regulator Screw (Qty: 4)
CAUTION:

Refer to Fastener Caution .

Procedure

  1. Remove the front side door water deflector.
  2. Loosen the window guide nuts, Do Not remove the nuts from the guide.
  3. Disconnect the electric connector from the regulator motor.

Tighten 
11 N.m (97 lb in)
2 Front Side Door Window Regulator

Procedure

  1. Transfer the front side door window regulator motor. Refer to Front Side Door Window Regulator Motor Replacement .
  2. Inspect the door window for proper operation before installing the door trim panel.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.