Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
Install the front lower grille (1) to the front bumper fascia assembly.
- CAUTION:
Refer to Fastener Caution .
Tighten the front lower grille screws (1) [4x] to 2.5N.m (22 lb in).
Install the ambient air temperature sensor (1) to the lower grille.
Install the electrical wiring harness (3).
- Connect the ambient air temperature sensor connector (2).
- Attach the electrical wiring harness retainers (1) to the bumper fascia and grille.
- Front Bumper Energy Absorber Replacement (Base)Front Bumper Energy Absorber Replacement (RS)
- Front Bumper Fascia Replacement
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.