Hazard Warning Switch Replacement

2019 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION Hazard Warning Switch Replacement
WARNING: This page is about a different car, the 2018 Chevrolet Sonic. However, it is still accessible from the selected car via links, so may be relevant.
GM2496185Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Remove the heater and air conditioning control. Refer to Heater and Air Conditioning Control with Cable Control Replacement .
1 Hazard Warning Switch Bolts (Qty: 2)
CAUTION:

Refer to Fastener Caution .


Tighten 
1.2 N.m (11 lb in)
2 Hazard Warning Switch
Procedure 
Disconnect the electrical connector.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.