Liftgate Latch Replacement

2019 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION Liftgate Latch Replacement
WARNING: This page is about a different car, the 2018 Chevrolet Sonic. However, it is still accessible from the selected car via links, so may be relevant.
GM2479214Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Remove the liftgate trim finish panel. Refer to Liftgate Trim Finish Panel Replacement (Hatchback) .
  2. Remove the liftgate latch cover.
1 Liftgate Latch Screw (Qty: 2)
CAUTION:

Refer to Fastener Caution .


TightenΒ 
22 N.m (16 lb ft)
2 Liftgate Latch Assembly

Procedure

  1. Disconnect the electrical connector.
  2. Adjust the liftgate if needed.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.