SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TAHOE LS, 4WD, GAS/ETHANOLREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 49 (WIPER SYSTEM AND WASHER SYSTEM)REPAIR INSTRUCTIONSWINDSHIELD WASHER SOLVENT CONTAINER HOSE REPLACEMENT
2019 Chevrolet Tahoe LS, 4WD, Gas/Ethanol

Windshield Washer Solvent Container Hose Replacement

2019 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION Windshield Washer Solvent Container Hose Replacement
WARNING: This page is about a different car, the 2018 Chevrolet Sonic. However, it is still accessible from the selected car via links, so may be relevant.
GM2497852Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Remove the left front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement (Front)Front Wheelhouse Liner Replacement (Rear)Front Wheelhouse Liner Replacement (with WFK) .
1 Windshield Washer Pump Hose

Procedure

  1. Place a clean suitable drain pan under the washer pump area.
  2. Pull the hose from the windshield washer pump spout first.
  3. Recover the windshield washer solvent from inside the hose.
  4. Disconnect the windshield washer pump hose from the windshield washer nozzle hose near the front fender front bracket.
  5. Disengage the windshield washer pump hose from the two retention clips on the windshield washer container.
  6. Remove the windshield washer pump hose from the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.