SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TAHOE LS, 4WD, GAS/ETHANOLREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 49 (WIPER SYSTEM AND WASHER SYSTEM)REPAIR INSTRUCTIONSWINDSHIELD WASHER SOLVENT CONTAINER FILLER TUBE REPLACEMENT
2019 Chevrolet Tahoe LS, 4WD, Gas/Ethanol

Windshield Washer Solvent Container Filler Tube Replacement

2019 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION Windshield Washer Solvent Container Filler Tube Replacement
WARNING: This page is about a different car, the 2018 Chevrolet Sonic. However, it is still accessible from the selected car via links, so may be relevant.
GM2497092Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedure

  1. Open and support the hood assembly.
  2. Grasp the top portion of the windshield washer container filler tube and rotate the tube 1/8 turn counterclockwise to unlock from the windshield washer solvent container lock tabs.
  3. Pull the tube straight from the windshield washer solvent container.
  4. Inspect and/or replace the seal on the windshield washer container filler tube if damaged.
1 Windshield Washer Solvent Container Filler Tube

Procedure

  1. Inspect the seal on the filler tube, replace as needed.
  2. Remove and transfer the windshield washer solvent container cap.
  3. Upon installation of the windshield washer solvent container filler tube back into the windshield washer solvent container, ensure to twist the filler tube 1/8 turn clockwise and lock the filler tube into the container lock tabs.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.