Windshield Multifunction Sensor Mount Bracket Cover Insert Replacement

2019 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION Windshield Multifunction Sensor Mount Bracket Cover Insert Replacement
WARNING: This page is about a different car, the 2018 Chevrolet Sonic. However, it is still accessible from the selected car via links, so may be relevant.
GM4625966Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
1 Windshield Multifunction Sensor Mount Bracket Cover Insert

Procedure

  1. Using a plastic trim tool, carefully pry downward on the cover to release from windshield.
  2. Squeeze upper tabs on insert and pull apart from cover.
NOTE:

The windshield multifunction sensor mount bracket cover and cover insert has to be removed from the windshield as a single unit to prevent damage to mirror.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.