Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Disassembly Procedure
- Strut Assembly - Remove - Strut Assembly Removal and Installation
- NOTE:
The spring is compressed when the strut moves freely.
Install the strut assembly (2) in a suitable spring compressor (1) and compress the front spring.
Use a suitable bit (1) and socket (2) to loosen the front suspension strut mount nut.
Slowly loosen the spring compressor (1) to access the strut assembly components to be serviced.
Remove the following components:
- Front Suspension Strut Mount (1)
- Front Coil Spring Upper Insulator (2)
- Front Coil Spring (3)
- Front Suspension Strut Bumper (4)
- Front Suspension Strut (5)
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.