Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Assembly Procedure
Install the following components:
- Front Suspension Strut (5)
- Front Suspension Strut Bumper (4)
- Front Coil Spring (3)
- Front Coil Spring Upper Insulator (2)
- Front Suspension Strut Mount (1)
Slowly tighten the spring compressor (1) until the front suspension strut mount nut can be started by hand.
Install the front suspension strut mount nut and tighten it as much as possible by hand.
- Use a suitable bit (1) and socket (2) to tighten the front suspension strut mount nut to 65 N.m (48 lb ft).
- Remove the strut assembly from the spring compressor.
- Strut Assembly - Install - Strut Assembly Removal and Installation
Refer to Fastener Caution .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.