Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TAHOE LS, 4WD, GAS/ETHANOLREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 46 (FRONT SUSPENSION SYSTEM)REPAIR INSTRUCTIONSFRONT LOWER CONTROL ARM BALL STUD REPLACEMENTREMOVAL PROCEDURE
2019 Chevrolet Tahoe LS, 4WD, Gas/Ethanol
Removal Procedure
2019 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION Removal Procedure
WARNING: This page is about a different car, the 2018 Chevrolet Sonic. However, it is still accessible from the selected car via links, so may be relevant.
- Lower Control Arm - Remove - Lower Control Arm Replacement
Vertically drill a hole through the rivet (1) using a 5 mm (0.197 in) diameter drill bit.
Enlarge the pre-drilled hole (1) using a 8 mm (0.315 in) drill bit.
- Remove the rivet head of each rivet using a flat chisel.
- Remove the remaining piece of each rivet using a punch.
Front Lower Control Arm Ball Stud (1) @Front Lower Control Arm (2) - Remove
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.