SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TAHOE LS, 4WD, GAS/ETHANOLREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 35 (12 V STARTING AND CHARGING SYSTEM)REPAIR INSTRUCTIONSGENERATOR REPLACEMENT (LUV)REMOVAL PROCEDURE
2019 Chevrolet Tahoe LS, 4WD, Gas/Ethanol

Removal Procedure

2019 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION Removal Procedure
WARNING: This page is about a different car, the 2018 Chevrolet Sonic. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Remove the drive belt. Refer to Drive Belt Replacement .
  4. Remove the drive belt tensioner. Refer to Drive Belt Tensioner Replacement .
  5. GM2508846Courtesy of GENERAL MOTORS COMPANY

    Remove the engine harness connector (1) and the battery positive cable generator fastener (2).

  6. Remove the battery positive cable (3) from the back of the generator.
  7. GM2508849Courtesy of GENERAL MOTORS COMPANY

    Remove the generator mounting fasteners (1) and remove the generator (2) from the engine.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.