SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TAHOE LS, 4WD, GAS/ETHANOLREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 34 (FRAME AND UNDERBODY)REPAIR INSTRUCTIONSFRONT WHEELHOUSE LINER INNER FRONT EXTENSION REPLACEMENT (RIGHT, LWE, LUW)
2019 Chevrolet Tahoe LS, 4WD, Gas/Ethanol

Front Wheelhouse Liner Inner Front Extension Replacement (Right, LWE, LUW)

2019 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION Front Wheelhouse Liner Inner Front Extension Replacement (Right, LWE, LUW)
WARNING: This page is about a different car, the 2018 Chevrolet Sonic. However, it is still accessible from the selected car via links, so may be relevant.
GM2965819
Callout Component Name

Preliminary Procedure

  1. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  2. Remove the front fascia opening lower cover. Refer to Front Bumper Fascia Opening Lower Cover Replacement (Base)Front Bumper Fascia Opening Lower Cover Replacement (RS) .
  3. Remove the front wheelhouse front liner. Refer to Front Wheelhouse Liner Replacement (Front) Front Wheelhouse Liner Replacement (with WFK) 
  4. Remove the air cleaner intake duct. Refer to Air Cleaner Inlet Duct Replacement
1 Front Wheelhouse Liner Inner Front Extension Screw (Qty: 2)
CAUTION:

Refer to Fastener Caution .


Tighten 
3 N.m (27 lb in)
2 Front Wheelhouse Liner Inner Front Extension Push-In Retainer (Qty: 3)
3 Front Wheelhouse Liner Inner Front Extension
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.