Installation Procedure

2019 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION Installation Procedure
WARNING: This page is about a different car, the 2018 Chevrolet Sonic. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM2191968Courtesy of GENERAL MOTORS COMPANY

    Install the throttle fasteners (2) along with a NEW throttle body seal ring (1).

  2. CAUTION:

    Refer to Fastener Caution .

  3. Install the 4 throttle body fastener (3) and tighten to 8 N.m (71 lb in).
  4. Install the charge air cooler outlet air hose to the throttle body. Refer to Charge Air Cooler Outlet Air Hose ReplacementΒ .
  5. Connect the throttle body wiring harness connector.
  6. Perform the intake system learned values reset. Intake System Learned Values ResetΒ 
  7. Perform the throttle body idle air flow compensation reset. Throttle Body Idle Air Flow Compensation ResetΒ 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.