Intake Air Pressure and Temperature Sensor Replacement

2019 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION Intake Air Pressure and Temperature Sensor Replacement
WARNING: This page is about a different car, the 2018 Chevrolet Sonic. However, it is still accessible from the selected car via links, so may be relevant.
GM2671064Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Remove the left front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement (Front)Front Wheelhouse Liner Replacement (Rear)Front Wheelhouse Liner Replacement (with WFK) .
1 Intake Air Temperature and Pressure Sensor Fasteners (Qty 2)
CAUTION:

Refer to Fastener Caution .

2 Intake Air Temperature and Pressure Sensor
Procedure 
Disconnect the electrical connector.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.