Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TAHOE LS, 4WD, GAS/ETHANOLREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 32 (ENGINE CONTROLS/FUEL - 1.4L (LUV) - REPAIR INSTRUCTIONS)REPAIR INSTRUCTIONSIGNITION COIL REPLACEMENTINSTALLATION PROCEDURE
2019 Chevrolet Tahoe LS, 4WD, Gas/Ethanol
Installation Procedure
2019 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION Installation Procedure
WARNING: This page is about a different car, the 2018 Chevrolet Sonic. However, it is still accessible from the selected car via links, so may be relevant.
- Install the ignition coil.
Remove EN-6009 remover (1) from ignition coil (2).
- CAUTION:
Refer to Fastener Caution .
Install the 2 ignition coil bolts (1) and tighten to 8 N.m (71 lb in).
Connect ignition coil wiring harness plug (2) to ignition coil (1).
- Install engine cover. Refer to Engine Cover Replacement .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.