Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
- NOTE:
Lubricate the 4 fuel injector seal rings (2) with clean engine oil.
Install the fuel injection fuel rail assembly (1) to the intake manifold. Use NEW fuel injector seal rings (2).
- CAUTION:
Refer to Fastener Caution .
Install the 2 fuel injection fuel rail bolts (1) and tighten to 7 N.m (62 lb in).
- Install the ground cable and the ground cable nut (2) and tighten.
Connect the 4 fuel injector wiring harness plugs (2).
- Clip the ECM wiring harness to the retainer clip (1) and the camshaft cover.
- Remove the positive crankcase ventilation pipe from the intake manifold. Refer to Positive Crankcase Ventilation Pipe Removal .
- Install the fuel feed pipe to the fuel injection fuel rail. Refer to Fuel Feed Pipe Replacement .
- Install the engine sight shield. Refer to Engine Cover Replacement .
- Connect battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.