Air Cleaner Assembly Replacement

2019 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION Air Cleaner Assembly Replacement
WARNING: This page is about a different car, the 2018 Chevrolet Sonic. However, it is still accessible from the selected car via links, so may be relevant.
GM2191936Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
1 Air Cleaner Outlet Duct Clamp.
Procedure 
Loosen clamp and remove air cleaner outlet duct from air cleaner assembly.
2 Mass Flow Sensor
Procedure 
Disconnect mass air flow sensor wiring harness plug from mass air flow sensor and unclip from retainer clip.
3 Air Cleaner Assembly
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.