Installation Procedure

2019 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION Installation Procedure
WARNING: This page is about a different car, the 2018 Chevrolet Sonic. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM2495432Courtesy of GENERAL MOTORS COMPANY

    Install a NEW O-ring (2) and the fuel pump module (1).

  2. GM2495431Courtesy of GENERAL MOTORS COMPANY

    Using the EN 48279 wrench, install the lock ring (1) by turning clockwise.

  3. GM2495427Courtesy of GENERAL MOTORS COMPANY

    Connect the electrical connectors (1).

  4. Connect the evaporative emission and fuel lines (2). Refer to Plastic Collar Quick Connect Fitting ServiceΒ .
  5. Install the fuel tank. Refer to Fuel Tank Replacement (Steel Tank)Β .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.