K33 HVAC Control Module X2

2019 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION K33 HVAC Control Module X2
WARNING: This page is about a different car, the 2017 GMC Canyon and 2017 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
GM1664553
Connector Part Information
  • Harness Type: Instrument Panel
  • OEM Connector: 31410-1202
  • Service Connector: 15126709
  • Description: 20-Way F 64 Series, Sealed (BN)
Terminal Part Information

Terminal Type ID Terminated Lead Diagnostic Test Probe Terminal Removal Tool Service Terminal Tray Name Core Crimp Insulation Crimp
I 13575867 J-35616-64B (LT BU) J-38125-215A SAIT-A03T-M064 Yazaki 14 P P
Pin Size Color Circuit Function Terminal Type ID Option
1 0.5 RD/VT 3340 Battery Positive Voltage I -
2 0.35 GN 5060 Low Speed GMLAN Serial Data I -
3 - - - Not Occupied - -
4 0.35 GN/YE 7531 Local Interconnect Network Serial Data Bus 9 I -
5 - 6 - - - Not Occupied - -
7 0.5 VT 3195 Auxiliary Heater Control I -
8 0.5 BK 2050 Ground I -
9 0.35 VT/GY 539 Run/Crank Ignition 1 Voltage I -
10 0.5 L-BU/YE 7574 Electric Variable Displacement Control I -
11 0.5 L-BU/BN 7573 Electric Variable Displacement Supply I -
12 - 14 - - - Not Occupied - -
15 0.35 L-BU/GY 754 Blower Motor Speed Control I -
16 - 17 - - - Not Occupied - -
18 0.35 BK/YE 1791 Air Temperature Door Control Low Reference I -
19 0.35 BN/VT 193 Rear Defog Relay Control I -
20 - - - Not Occupied - -
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.