Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TAHOE LS, 4WD, GAS/ETHANOLREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 137 (ANTILOCK BRAKE SYSTEM)SPECIFICATIONSFASTENER SPECIFICATIONS
2019 Chevrolet Tahoe LS, 4WD, Gas/Ethanol
Fastener Specifications
2019 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION Fastener Specifications
WARNING: This page is about a different car, the 2019 Chevrolet Suburban 3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Brake Pipe Fitting - Left Front, Left Rear, Right Rear, Right Front | 18 N.m (13 lb ft) |
| Brake Pressure Modulator Valve Bolt | 10 N.m (89 lb in) |
| Brake Pressure Modulator Valve Bracket Bolt | 22 N.m (16 lb ft) |
| Brake Pressure Modulator Valve Primary Pipe Fitting | 32 N.m (24 lb ft) |
| Brake Pressure Modulator Valve Secondary Pipe Fitting | 32 N.m (24 lb ft) |
| Electronic Brake Control Module Bolt | 3 N.m (27 lb in) |
| Wheel Speed Sensor Bolt - Front and Rear | 13 N.m (115 lb in) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.