Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TAHOE LS, 4WD, GAS/ETHANOLREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 137 (ANTILOCK BRAKE SYSTEM)REPAIR INSTRUCTIONSBRAKE PRESSURE MODULATOR VALVE BRACKET REPLACEMENTREMOVAL PROCEDURE
2019 Chevrolet Tahoe LS, 4WD, Gas/Ethanol
Removal Procedure
2019 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION Removal Procedure
WARNING: This page is about a different car, the 2019 Chevrolet Suburban 3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Place the ignition switch in the OFF position.
- Brake Pressure Modulator Valve Replacement - Remove
Brake Pressure Modulator Valve Bolt (1) - Remove
- NOTE:
Do NOT pry on the accumulator caps on the underside of the brake pressure modulator valve.
Brake Pressure Modulator Valve Bracket (1) - Remove
- Inspect the insulators for damage and replace, if necessary.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.