Circuit/System Verification

2019 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION Circuit/System Verification
WARNING: This page is about a different car, the 2019 Chevrolet Suburban 3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON.
  2. Verify that no other DTCs are set except for C0242.
    • Go to next step: If no other DTCs are set 
  3. Replace the K20 Engine Control Module.
  4. Verify that DTC C0242 does not set while operating the vehicle within the Conditions for Running the DTC.
    • If DTC sets 

      Replace the K17 Electronic Brake Control Module.

    • Go to next step: If DTC does not set 
  5. All OK.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.