Rearview Driver Information Camera Replacement

2019 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION Rearview Driver Information Camera Replacement
WARNING: This page is about a different car, the 2018 Chevrolet Sonic. However, it is still accessible from the selected car via links, so may be relevant.
GM3327311
Callout Component Name
Preliminary ProcedureΒ 
Remove the rear compartment lid applique, refer to Rear Compartment Lid Applique Replacement , or the liftgate side applique, refer to Liftgate Side Applique Replacement (Hatchback) .
NOTE:

The coax cable repair kit is only to be used for antenna coax cable repairs. It should not be used for any camera coax cable repairs as the repair kit connector ends are not sealed, and will fail due to corrosion.

1 Rearview Driver Information Camera

Procedure

  1. Disconnect the electrical connector.
  2. Depress the clip fingers and push outward to remove the rearview camera from the applique.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.